Expression Erros when extracting Master Properties

[ulfstein]

Hi,

I have finally completed the rig of the project that I'm working on but am now discovering that extracting the Master Properties is throwing up a bunch of expression errors (see attached image).

It's looking for layer named "C | Connector" but the layer is there in the pre-comped rig. I've been trying desperately to figure out what's going on here but am not managing to get to the bottom of this.

Any help would be hugely appreciated. I can upload a copy of the project if that helps.

Many thanks.

[Duduf]

Hi,

This may be because the "C | Connector" controller is not extracted for some reason but some expressions look for it outside of the precomp. I'm not sure though, just send me the project and I'll have a look at that.

Apart from these errors, does the rig work correctly ?

[ulfstein]

Hi Duduf,

Thanks for getting back to me on this. Yes, the rig prior to extracting is working fine. I've uploaded the project here: https://www.dropbox.com/sh/nshizqk4whtf ... uGmHa?dl=0

Many thanks