Hello.
I'm using Duik 2.0 and trying to rig a robot following the 9 hour tutorial for 1.6.
My issue is. I set up a custom structure, link layers to structure. When I hit auto-rig I get one controller at the foot on the custom structure that then just move everything around when I adjust the positioning. According to the tutorial it should link things properly. I'm fairly new so I'm sure its a user error. If anyone has any tips or solutions I'd be very grateful.
Thank you,
Your Friend
This forum has been permanently closed and archived; you can still access all content but can't post anymore.
Of course, you can still join us in other places!
To get support and talk about RxLaboratory and with the team, come here: https://rainboxlab.org/support/
Of course, you can still join us in other places!
To get support and talk about RxLaboratory and with the team, come here: https://rainboxlab.org/support/
Custom Robot Rig Issue
-
- Posts: 7
- Joined: Tue Jan 28, 2020 11:05 pm
Custom Robot Rig Issue
Last edited by YourFriend on Mon Feb 03, 2020 6:44 pm, edited 1 time in total.
-
- Posts: 7
- Joined: Tue Jan 28, 2020 11:05 pm
Re: Custom Robot Rig Issue
Taps microphone... ... .. .
-
- Posts: 7
- Joined: Fri Nov 22, 2019 8:07 pm
Re: Custom Robot Rig Issue
I'm not sure of the issue. When you rig auto-rig a leg, you get one controller shaped like a foot that will control the whole leg structure.
-
- Posts: 7
- Joined: Tue Jan 28, 2020 11:05 pm
Re: Custom Robot Rig Issue
Hello. Thank you for your reply. I did figure it out. I tried deleting this but I had already replied to my own thread preventing me from deleting. Thank you again.